Spruce Enhance Your Kitchen With Area Tradesmen

Spruce Enhance Your Kitchen With Area Tradesmen

Blog Article

The common toilet in our home is made up of different parts. You have the ceramic toilet a toilet seat attached to it and a flush tank. Some toilets do not have a flush tank and water is passed to flush the toilet directly through a broad water pipe.

The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you slow drain a water leak! At some point almost all homeowners run into this problem.

There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.



If you need to add copper pipe make sure that you clean the old and new pipe by using sandpaper, inside and out. If it's not clean the solder will not flow into the joint. Another tip is to not over wrap the mail threaded pipe with tape, this can cause a leak. Twice around should be enough. Also, don't over tighten it.

If you do experience a broken pipe, you must act quickly to prevent further water damage to your home or business. The first thing you must do is shut off the water immediately. Know where the water shut off valve is located and make sure all members of the household are aware of its location and how to shut it off.

The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.

Turn the water off at the main shutoff valve at the street. You should be able to take a pair of pliers(or your bare hands) and turn the valve at the water meter to shut off the water to your home. Once you have shut off the water you can cut the pipe around the leak and make the repair.

Once you've located the water shut off, turn it off. Now, you can turn your attention to trying to contain the water damage caused by any leaking. Get towels, fans, blankets, or anything else to try and sop up water that is sitting on carpet or wood floors. Linoleum floors usually don't undergo much damage from having water sitting on them, unless there are cracks in the linoleum (often invisible) where the water can seep in. When your Queens plumber arrives, you will be one step ahead by following these instructions.